Vaisala HMDW80 User Manual download pdf (Page 25)

Chapter 3 ________________________________________________________________ Installation

VAISALA ________________________________________________________________________ 23

Configuration and Wiring

To minimize working at height at the installation location, prepare the

transmitter configuration and wiring before climbing up.

1. Open the six screws that hold the transmitter cover.

2. Check that the DIP switches are set as desired. See section DIP

Switches on page 30.

3. Route the power and signal cable to the screw terminals and

connect the wires. Refer to section Wiring on page 26.

4. Disconnect the screw terminal block by pulling it away from the

component board.

5. Adjust the length of cable between the cable gland and the terminal

block. Make the cable short enough to close the cover without

leaving a cable loop in the transmitter.

6. Tighten the cable gland. Leave the cover off for now.

1304-059

Figure 14 Location of DIP Switches and Screw Terminal

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 50 51

No comments

Vaisala HMDW80 User Manual Page 25