USER'S GUIDE____________________________________________________________________
116 _________________________________________________________________ M210796EN-E
7. Select Scale, lower limit, by pressing the up/down arrow buttons.
Press the SET key. Adjust the lower limit value by pressing the
arrow buttons up/down/left/right. Press the OK key to confirm your
setting.
8. Select Scale, upper limit by pressing the up/down arrow buttons.
Press the SET key. Adjust the upper limit value by pressing the
arrow buttons up/down/left/right. Press the OK key to confirm your
setting.
9. Press the EXIT key to return to the basic display.
AMODE/ASEL
Use the serial line to select and scale the analog output quantities.
Connect the transmitter to the PC. Open the terminal connection between
your PC and the transmitter.
1. Check the analog output modes with the AMODE command.
Example:
>amode
Ch1 output : 0...1V
Ch2 output : 0...1V
>
2. Select and scale the quantities for the analog outputs with the
command ASEL. Note that the optional quantities can be selected
only if they have been selected when ordering the device.
ASEL [xxx yyy zzz]
where
xxx
= Quantity of channel 1
yy
= Quantity of channel 2
zzz
= Quantity of the optional analog output channel 3
Enter always all the quantities for all outputs. For quantities and their
abbreviations see Table 4, Table 5 and Table 6 on page 19.
Use the command ASEL [xxx yyy] as shown in the example below when
using a device with two analog outputs.
Comments to this Manuals