Vaisala HydroMet User's Guide download pdf (Page 132)

User's Guide ______________________________________________________________________

130 __________________________________________________________________M210784EN-E

LASTVAL Command

If the value in the report changes to ////, you can check the

measurement’s/sensor’s value with the LASTVAL command. Give the

command in the terminal connection. When you use the raw parameter,

the measured value before any validation and the status produced

during validation are shown. When you use the corresponding signal

name, the validated value is shown.

LASTVAL [Measurement] [unconv | Signal name]

Examples:

The command with the signal name parameter (in the following case,

TA) produces the following response:

/ > LASTVAL TAMeasQMH101_1 TA

Status:1 Value:20.490570

where

Measurement = Name of the measurement as it is defined in the

setup file

unconv = Parameter that gives the status and the electrical

value of the measurement signal before

conversion

Signal name = Parameter that gives the validated value of the

measurement

where

Status:1 = Value is valid.

Value:20.490570 = Validated value for the temperature

measurement is 20.49xxxx.

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 159 160

No comments

Vaisala HydroMet User's Guide Page 132