Vaisala HMT140 Service Manual download pdf (Page 11)

____________________________________________________________________ English

VAISALA _________________________________________________________________

Hardware Setup

To set up the device initially:

1. Open the case by pulling out and up with your fingers while pressing the

release tab located between the two glands with your thumb. (See the

HMT140 components diagram in “Wiring” section for location of release

tab). A slot screwdriver may be used to pry if you are unable to open the

case by hand.

2. Ensure the power switch on the device is in the OFF position.

3. Install three 3.6V lithium batteries as indicated in the wiring section.

Note: Use only Part # 236318SP Vaisala 3.6V Lithium Thionyl Chloride

batteries.

4. Ensure that the HMT140 Configuration Cable is disconnected.

5. Turn the device on by moving the power switch on the device to the “ON”

position.

HMT140 Utility Installation

Before using the HMT140 Configuration Cable cable to configure the HMT140, the provided

software must be installed on the PC. The driver is compatible with Windows 2000, Windows

XP, Windows 7, and Windows Server 2003.

To set up the software:

1. Disconnect the HMT140 Configuration Cable if it is already connected.

2. Insert the media that came with the cable, or download the software from

http://www.vaisala.com/hmt140

3. Run the HMT140 installation program (HMT140UtilitySetup.exe).

4. Accept the license agreement terms and continue by pressing Next to accept

the installation defaults. The installation of the driver may take several

minutes.

5. After the software has been installed, connect the HMT140 Configuration

Cable to a USB port on your PC. You can then proceed to configure the

utility using the steps below.

If you wish to remove the software, you can do so by uninstalling the entry for HMT140

Utility under the publisher Vaisala from the “Programs and Features” or “Add or Remove

Programs” feature in the Windows Control Panel.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

Vaisala HMT140 Service Manual Page 11