Vaisala HMT140 Service Manual download pdf (Page 12)

QUICK GUIDE ______________________________________________________________

____________________________________________________________ M211484EN-A

HMT140 Utility Software Setup

Use the following procedure to quickly set up the HMT140:

1. Turn on the HMT140 and wait 5 seconds.

2. Plug the USB connector on the HMT140 Configuration Cable to the

computer if it is not already connected.

3. Open the HMT140 Utility from the start menu.

4. Connect the end of the Configuration cable labelled “USB Wi-Fi

Programmer” to the HMT140 “CONFIG” pin header.

5. Click the Retrieve button to identify the HMT140.

6. If the IP address is static, uncheck the “IP Address Dynamically Assigned”

checkbox and enter the network parameters in “Network Settings”.

Otherwise leave this checkbox checked.

7. Enter the parameters for the “WLAN” (wireless LAN router settings).

8. Enter the Destination IP address/name and port number of the host.

(viewLinc server settings).

Note: If you do not know the information to enter for steps 6-9, please request

these parameters from your network administrator.

9. Click the Sensor tab and select a Transmit Period Time and number of tries

for the HMT140 if you do not wish to keep the default settings.

10. Click the Update button. The utility will configure the HMT140.

11. Click the Status tab and wait. Check that the settings appear as configured.

Click the “Get” button if they do not appear automatically.

12. Disconnect the HMT140 Configuration cable from the HMT140.

13. Wait 8 seconds.

14. Press the “SERVICE” button on the HMT140.

15.

Optional:

Enter a name for the saved settings in the Saved Settings field and

click the disk icon to save.

16. Refer to the viewLinc Administrator Guide to complete the process of

adding HMT140’s to viewLinc.

Battery Replacement

Use the following procedure to replace the batteries in the HMT140:

1. Open the case by pulling out and up with your fingers while pressing the

release tab located between the two glands with your thumb. (See the

HMT140 components diagram in “Wiring” section for location of release

tab).

2. Turn the power switch off.

3. Remove the batteries by pulling them up firmly. If the battery does not

come out easily, one of the battery tabs can be pulled out gently while

pulling up.

4. After replacing the batteries, press and hold the service button and turn the

power switch on. The LED light will flash and the device will beep 8 times.

5. Release the service button.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Vaisala HMT140 Service Manual Page 12

Comments to this Manuals

Related products and manuals for Security device components Vaisala HMT140