Vaisala MM70 User Manual download pdf (Page 21)

Chapter 3 ____________________________________ INSTALLATION AND MOUNTING OPTIONS

NOTE

The probe can be installed in the process through the ball valve

assembly provided that the process pressure is less than 10 bars. This

way, the process does not have to be shut down for installing or

removing the probe. However, if the process is shut down before

removing the probe, the process pressure can be max. 20 bars.

Mounting the Probe for Direct Measurement

(No Pressure)

1. Lift up the clasp nut, see picture below.

2. Install the probe into measuring position. When stopping the

measurement, pull down the clasp nut to clean the probe or just

wipe the probe with soft cloth.

0605-088

Figure 8 Direct Mounting

The following numbers refer to Figure 8 on page 19 above:

1 = Lift up the clasp nut

2 = Pull down to clean the probe

VAISALA _______________________________________________________________________ 19

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 70 71

No comments

Vaisala MM70 User Manual Page 21