Vaisala PTU200 Series User's Guide download pdf (Page 16)

USER'S GUIDE_______________________________________________________________________

12 ___________________________________________________________________ M210195EN-A

Software settings

SERI Serial bus settings

SERI b p d s x <cr>

where: (* = factory setting)

b = baud rate (300...9600*...38400)

p = parity (E = even*, O = odd, N =

none)

d = data bits (7* or 8)

s = stop bits (1* or 2)

x = duplex (F = full* or H = half)

<cr> = carriage return is generated by the

ENTER or RETURN key of the

host computer

The SERI command is used to set or inspect the serial bus settings of

the transmitter.

Examples:

>seri <cr>

9600 E71F

>seri 1200N81H<cr>

1200 N81H

>reset <cr>

PTU200 / 1.01

NOTE

Always give the RESET command after the SERI command to

activate the new serial bus settings.

ECHO Setting the serial bus echo on/off

ECHO x <cr>

where:

x=ONorOFF

The ECHO command can be used to set or inspect the echoing

condition of the transmitter. In OFF mode the transmitter does neither

output the '>' prompt character nor echo the given commands.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

No comments

Vaisala PTU200 Series User's Guide Page 16