Vaisala PTU200 Series User's Guide download pdf (Page 31)

CHAPTER 5________________________________________________________________ OPERATING

VAISALA _________________________________________________________________________ 27

SEND Outputting a single message only

SEND <cr>

This command is used to output one message at a time in the STOP

and RUN modes.

>reset <cr>

PTU200 / 1.01

>send <cr>

1013.25 hPa 22.9 %RH 22.4 'C

The user may also use his own one-message command if he has

previously specified one using the SCOM command (see Chapter on

page 11).

RESET Resetting the transmitter

RESET <cr>

The RESET command is used to reset the transmitter. All software

settings remain in the memory after reset or any power failure. The

RESET command must always be given if the serial bus settings, DIP

switch settings or the operating mode of the transmitter have been

changed.

Example:

>reset <cr>

PTU200 / 1.01

POLL mode

TABLE 5-2 Commands used in RUN and STOP modes

Function Command

single message output SEND

opening a transmitter OPEN

closing a transmitter CLOSE

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 63 64

No comments

Vaisala PTU200 Series User's Guide Page 31