Chapter 3 _______________________________________________________________ Installation
VAISALA _______________________________________________________________________ 31
Alternate Wiring Systems
There are three optional ways to connect the transmitter: using basic
wiring, using 8-Pin connector, or using D-9 connector.
The wiring system is selected when ordering the device. If a connector
is needed for wiring, it is set at the factory.
- When using basic wiring, see section Signal and Power Supply
Wiring below.
- When using 8-Pin connector, see section 8-Pin Connector on page
33.
- When using D-9 connector, see section D-9 Connector on page 34.
Signal and Power Supply Wiring
When wiring the power supply module, see section Power Supply
Module on page 41.
0506-028
Figure 15 Screw Terminal Block on Motherboard
Numbers refer to Figure 15 above:
1 = Power supply terminals 10 ... 35 VDC, 24 VAC
2 = User port (RS-232 terminals)
3 = Analog signal terminals
Comments to this Manuals