Vaisala HMP60 User's Guide download pdf (Page 25)

Chapter 3 ________________________________________________________________ Installation

VAISALA ________________________________________________________________________ 23

Drilling Instructions for Duct Installation Kit

0505-178

Figure 19 Drilling Instructions

The following numbers refer to Figure 19 above:

Mounting screw

Tension screw

Probe assembled in duct installation kit plastic pipe

Drill the holes for the duct installation kit as follows:

1. Use a 24-mm drill bit to drill a hole to the duct wall for the

humidity probe.

2. Drill holes for the duct installation kit mounting screws around the

hole in a square arrangement, 42 mm apart from each other. Use a

3.2-mm drill bit to drill the holes for the mounting screws

(four ST4.2×16-C-Z DIN 7981 screws).

Ø24

Ø3.2

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 72 73

USER'S GUIDE 1
CHAPTER 4 4
CHAPTER 5 4
CHAPTER 6 5
CHAPTER 7 5
List of Figures 6
List of Tables 6
GENERAL INFORMATION 7
Version Information 8
Related Manuals 8
Documentation Conventions 8
ESD Protection 9
Recycling 9
Regulatory Compliances 10
Trademarks 10
License Agreement 10
Warranty 11
PRODUCT OVERVIEW 12
1210-009 13
Filter Options 15
Probe Mounting Clamp 16
1209-002 17
1209-003 17
HMP110D and HMP110T 19
Loop Power Converter 20
1210-063 21
1210-062 21
0912-103 23
0912-102 23
0505-178 25
0912-104 27
0912-105 27
1210-031 29
Power Supply Requirements 30
OPERATION 31
0807-004 35
List of Serial Commands 37
View Device Information 38
View Calibration Information 39
View Order Code 39
View Serial Number 39
Serial Line Output Commands 40
Set Serial Line Settings 41
Set Serial Interface Mode 42
Set Output Interval 43
Set Measurement Filtering 43
Set Probe Address 44
Set Serial Interface Delay 44
Set Measurement Units 45
Calibration Commands 46
CT [reference]<cr> 47
CT command 48
Other Commands 49
Scaling 50
Extend Analog Output Range 52
Extend Maximum RH Reading 52
Display Command List 53
Reset the Probe 54
Restore Factory Settings 54
MAINTENANCE 55
Calibration Procedure 56
(HMP110, HMP110D and HMP113) 56
Two-Point Adjustment of RH 58
HMP113) 58
HMP110T) 59
Measurement 62
Repair Maintenance 63
TROUBLESHOOTING 65
Technical Support 66
TECHNICAL DATA 67
Relative Humidity 68
Temperature 68
Dewpoint 68
Performance (HMP113) 69
Performance (HMP110T) 69
Operating Environment 70
Inputs and Outputs 70
Mechanics (HMP63 and HMP113) 71
Options and Accessories 72
*M211060EN* 73

Comments to this Manuals

No comments

Vaisala HMP60 User's Guide Page 25

Comments to this Manuals

Related products and manuals for Measuring, testing & control Vaisala HMP60