Vaisala HMP230 User Manual download pdf (Page 113)

HMP230 SERIES

M210225en-A Appendix 3: RS 485/422 serial port module

107

1. INSTALLATION

Switch the transmitter off.

Resistors R2, R3 and R4 between connectors X4 and X5 in the component

board in the cover of the transmitter are removed with side-cutting pliers. The

module is plugged in connectors X4 and X5 on the main board of the

HMP230 transmitter; connector X1 on the module board to connector X4 and

connector X2 to connector X5.

h1 Ch2

--++

X HI

TX LO

X1X2

HIHI

Jumper ( ) selections for the

RS 485/422 serial bus module

Single pair

Dual pair

serial bus

module

Cut off the resistors R2, R3 and R4 on the main board.

New signal names for X6 screw terminal are on the module.

Follow the instructions on the module:

X1 to X4 and

X2 to X5 on the mother board

NOTE! If the transmitter is NOT at the end

of the bus OR the line has a dynamic line

termination, the resistors R3 and R6 have

to be removed!

RX GND TX

24V

RS 485/422

Connect the data wires to screw terminal X6 on the main board. Switch the

power on.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 162 163

No comments

Vaisala HMP230 User Manual Page 113