Vaisala HMP230 User Manual download pdf (Page 154)

HMP230 SERIES

Appendix 9: Re-gaining M210225en-B

148

4. DISPLAY/KEYPAD COMMANDS

Press the CL key to enter the command mode. Select More from the first

menu using the arrow keys and press ENT key. Select again More from the

second menu and press ENT. The following menu is displayed:

Select Regen and press ENT.

To change or inspect the re-gaining parameter settings select Regen. settings

and press ENT. To start re-gaining manually select Regeneration and press

ENT.

4.1. Re-gaining parameters

The re-gaining parameters are displayed in a sequence of

• status of the automatic re-gaining

• re-gaining interval

• duration of heating

• temperature difference

• settling time

• k parameter

Each setting can be changed by entering a new parameter value using the

arrow keys. NOTE: disconnect the security lock jumper for changing these

parameters! After the parameter sequence the menu Regen.settings/

Regeneration is displayed again. If you want to leave the parameters for the

main menu, press CL once or several times. This leaves the rest of the

parameters unchanged.

NOTE

To activate the new parameter settings immediately, the

transmitter must be switched off/on. Otherwise the

transmitter waits until the end of the old re-gaining

interval and then starts re-gaining using the new

parameters.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 162 163

No comments

Vaisala HMP230 User Manual Page 154