Vaisala HydroMet User's Guide download pdf (Page 139)

Chapter 4 ____________________________________________ Basic Use of Lizard Setup Software

VAISALA______________________________________________________________________ 137

Table 20 Alarms

Col # Column Label Content

1 Name Alarm name

2 Interval [s] Condition test interval in seconds

3 Source Source for the tested variable

4 Variable Name of the tested variable

5 Target Act. Target report or the log group when an alarm

becomes or already is active

6 Target Deact. Target report or the log group when an alarm

becomes or already is inactive

7 Test Alarm condition in comparison to minimum and

maximum values:

- Below min = Below minimum

- Above max = Above maximum

- Outside min - max = Between minimum and

maximum

- Between min - max = Between minimum and

maximum

8 Min Value for the minimum limit

9 Max Value for the maximum limit

10 Limit Source Source for the limit when an other variable is

used as the limit

11 Limit Variable Name of the limiting variable when an other

variable is used as the limit

Table 21 Timed Events

Col # Column Label Content

1 Timer # Timer number. Use this as the first parameter

<tevId> in ctev command when changing timer

intervals through the service or remote

command interface:

ctev <tevId> <interval>

2 Target Target component name

3 Event Triggered event type

4 Interval [s] Triggering interval in seconds

5 Synch [s] Synchronization time in seconds counted from

00:00:00 hours

6 Timezone Time zone: Local or UTC (formerly Greenwich

mean time)

7 Timer type Timer type: Periodic or Single shot

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 217 218

No comments

Vaisala HydroMet User's Guide Page 139