Chapter 5 ________________________________________ Advanced Use of Lizard Setup Software
VAISALA______________________________________________________________________ 195
Configuring Calculations and Reports
Accumulator with Predefined Reset
Time
You can use the Accumulator component to add a source parameter to
the destination parameter in order, for example, to accumulate annual
precipitation in the system and to reset the calculation at a predefined
moment.
The destination parameter is stored in the static parameters to maintain
its value over reset or power shutdown. In addition, the destination
parameter can be reset according to a predefined schedule. The
Accumulator is always incremented when the source variable is
measured.
Configuring Accumulator
To select the Accumulator component, proceed as follows:
1. In the Calculations view, choose Miscellaneous calculations
(Misc) by clicking on the correct button below the Available list
box; see Figure 98 on page 196.
2. Select the Accumulator from the list by clicking on the item name
and then the Add button.
Comments to this Manuals