Vaisala WINDCAP WS425 User's Guide download pdf (Page 49)

Chapter 4 _______________________________________________________________ Installation

VAISALA _______________________________________________________________________ 47

1103-054

Figure 20 Tightening the Connector

The following number refers to Figure 20 above:

1 = Tighten the connector by rotating the ribbed part of the connector

by hand. DO NOT USE TOOLS.

NOTE

Verify that the connector is properly tightened to avoid water leakage and

damage to the sensor. If water leaks into the connector, this voids the

warranty for WMT700.

Checklist for Connection Cables

Take the following issues into account when installing WMT700:

- Routing of the cables depends on the mounting option selected for

WMT700. When mounting to a mast, the cable can be routed either

outside or inside the mast depending on the mast type and other

equipment (for instance, lightning rods) installed to the mast.

- Make sure that the cable is properly attached to the mast or cross arm

before starting the installation. Otherwise it may slip and fall down

during the installation procedure.

- It is important to attach the cable properly to avoid strain on the

connector. Too much strain may cause the cable to fall off, damage

the cable or connector, or make the cable or connector susceptible to

water leakage. The recommended minimum bending radius for the

cable is 70 mm.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 135 136

No comments

Vaisala WINDCAP WS425 User's Guide Page 49