Vaisala WINDCAP WS425 User's Guide download pdf (Page 83)

Chapter 6 ____________________________________________________ Configuration commands

VAISALA _______________________________________________________________________ 81

VERSION — Show Firmware Version

This command displays the label and version of the WMT700 software.

VERSION

WIND_GET — Get Calibration Data

This command fetches the WMT700 calibration date and other

calibration data. This information is mostly intended for Vaisala

technical support.

WIND_GET

Configuration Parameters

There are a number of parameters affecting WMT700 functionality.

Table 18 on page 82 lists the parameters for configuring WMT700

settings. Appendix D, Configuration Parameters on page 129 includes a

detailed description and the default values for each parameter and the

allowed values when using the WMT700 profile. Unless otherwise stated

in the table, the changes take place immediately after the command has

been sent.

To view and set parameter values, use the G and S commands.

NOTE

You can configure WMT700 by sending individual commands or by

loading a configuration file to the sensor. For instructions on configuring

all settings at once using configuration files, see section Loading Settings

from

Configuration File on page 87.

For information on configurable parameters and allowed values when

using WS425 and SDI-12 profiles, see Upgrading from Vaisala

WINDCAP

Ultrasonic Wind Sensor WS425 to WMT700 Technical

Reference.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 135 136

No comments

Vaisala WINDCAP WS425 User's Guide Page 83