Chapter 5 _________________________________________________________________ Operation
12. Wait for 4 seconds. WMT700 enters measurement mode
automatically.
13. To test the connection, enter configuration mode with the
following command:
$0OPEN<CR><LF>
14. Use the following command to return to measurement
mode:
CLOSE<CR><LF>
You can now start operating WMT700. Note that WMT700
does not send data messages automatically unless
configured to do so.
NOTE
In configuration mode, you can use any of the following end
-of-line
character combinations: <
CR><LF>, <CR>, or <LF>.
Entering Configuration Mode
This command switches the serial port to configuration mode.
The command works with any communication profile supported
by WMT700.
$aOPEN<CR><LF>
Value of the address parameter. If the value is 0, it
refers to any WMT700 address
VAISALA _______________________________________________________________________ 147
Comments to this Manuals