Appendix E ________________________________________________ WMT700 NMEA MWV Profile
WMT700 NMEA MWV Commands
This command polls data from WMT700 when the WMT700
NMEA MWV protocol is selected.
$--<id>Q,MWV*<chk><CR><LF>
Two-character talker ID of the polling unit
Two -character WMT700 sensor ID; AA … ZZ
Checksum field(8-bit XOR, excluding $ and *)
Carriage return code, ASCII 0DH
Line feed code, ASCII 0AH
NOTE
To use WMT700 with the WMT700 NMEA MWV profile, either set the
autoSend
parameter to 0 to enable polling or define a fixed output
autoInt parameter. If you are using automatic messages,
autoSend parameter must be set to 20.
VAISALA _______________________________________________________________________ 211
Comments to this Manuals