Appendix D ___________________________________________________ Configuration Parameters
APPENDIX D
CONFIGURATION PARAMETERS
This appendix lists the WMT700 configuration parameters.
Table 66 Parameter Descriptions
maximum of 40
characters.
Address for WMT700. Note that the
SDI-12, ASCII, NMEA Extended, ASOS,
and MES12 profiles use the first
character only.
SDI-12 only uses digits 1 … 9.
Value for AOUT1 and AOUT2 analog
output if wind measurement fails.
Gain for AOUT1 (wind speed) and
AOUT2 (wind direction).
Offset for AOUT1 and AOUT2.
aout2maxv
Hz, %
Analog output maximum value for
AOUT1 and AOUT2. The output is fixed
to this value. The unit depends on analog
aout2minv
Hz, %
Analog output minimum value for AOUT1
and AOUT2. The output is fixed to this
value. The unit depends on the analog
1 = Voltage
2 = Frequency
Analog output mode for AOUT1.
5 = Voltage
6 = Potentiometer
Analog output mode for AOUT2.
Resolution: 0.25
Automatic message interval in seconds.
This parameter affects both serial
communication and analog output.
Do not select a message interval that is
shorter than the time it takes to send a
1 = COM1 port
2 = COM2 port
Serial port to which WMT700 sends
automatic data messages.
messages disabled
Automatic data message number.
Selects the data message format for
This is a read-only parameter.
VAISALA _______________________________________________________________________ 205
Comments to this Manuals