Vaisala WINDCAP WS425 User's Guide download pdf (Page 162)

User's Guide ______________________________________________________________________

WS425 A/B ASCII Commands

Table 50 below lists the available commands for operating

WMT700 with the WS425 A/B ASCII profile.

Table 50 WS425 A/B ASCII Commands

Command

Description

Requests identification information for WMT700.

Starts measurement based on averaging time and fetches the data.

NOTE

The following WS425 A/B ASCII command cannot be used with

WMT700: Measurement Unit Change

For a list of configuration commands for WMT700, see

Table 63 on page

195

I — Identify Sensor

This command shows the vendor, model number, and version

information of WMT700.

Example of the command and response:

VAISALA WMT700 200

Wx — Start Measurement

This command starts wind measurement based on averaging time

and fetches the data automatically when the measurement has

finished. You must specify the averaging time in the command.

Averaging time supplied in the command (x) sets the averaging

time for WMT700, as if it was set with the S command. When

you change the averaging time, it applies to the next new wind

value.

where

Time for averaging wind speed and wind direction. The range

is from 1 to 9

160 __________________________________________________________________ M211095EN-E

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 220 221

No comments

Vaisala WINDCAP WS425 User's Guide Page 162