Appendix A __________________________________________ Complete Command Set for WMT700
APPENDIX A
COMPLETE COMMAND SET FOR
WMT700
Table 63 below lists all the commands available for WMT700.
Table 63 Command Set for All Profiles
Measurement Mode and
Displays a list of configuration commands.
Changes or displays serial port settings.
Switches the serial port to measurement mode.
Displays error codes and counts.
Displays either all or specified parameters.
Displays list of data messages and available values for
measurement unit, profile, baud rate, interface, and
Starts wind measurement based on the user-
configurable averaging time. WMT700 does not send
data messages automatically.
Changes selected parameters or defines new data
messages.
Starts continuous measurement.
Stops continuous measurement.
Displays the software version.
Fetches wind calibration information.
WMT700 profile
Starts wind measurement. The duration of the
measurement is based on the user-configurable
Measurement mode
WMT700 profile
Switches the serial port to configuration mode.
Measurement mode
WMT700 profile
Fetches data from WMT700.
Measurement mode
WMT700 profile
Switches WMT700 from normal operating mode to low-
power mode.
Measurement Mode
MES12 profile
Polls data from WMT700 in the MES12 data message
format.
Measurement mode
WS425 ASOS F/G profile
Requests average wind speed and direction message.
Measurement mode
WS425 ASOS F/G profile
Requests the verbose Built-In Test (BIT) results.
VAISALA _______________________________________________________________________ 195
Comments to this Manuals