Vaisala HUMICAP HMP41 User's Guide download pdf (Page 41)

Chapter 4 ________________________________________________________________ Operation

VAISALA _______________________________________________________________________ 39

Configuring Serial Line Operation

Set/Show Serial Line Settings

Use the SERI command to show or set the serial line settings for the

serial port that you are currently using (service port or user port).

Use the SAVE command after changing the settings to store them. The

new settings will be taken into use when the transmitter is reset or

powered up.

SERI [b p d s]<cr>

where

= baud rate (9600, 19200, 38400, 76800, 115200)

= parity (n = none, e = even, o = odd)

= data bits (7 or 8)

= stop bits (1 or 2)

Examples:

>seri

Baud P D S : 19200 N 8 1

>seri 9600 e 7 1

Baud rate : 9600

Parity : E

Data bits : 7

Stop bits : 1

>save

Saving settings...done

Set/Show Terminal Echo

To show or set the terminal echo status, use the ECHO command.

ECHO [ON/OFF]<cr>

Examples:

>echo

COM1 Echo : OFF

>echo on

COM1 Echo : ON

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 95 96

No comments

Vaisala HUMICAP HMP41 User's Guide Page 41