Vaisala WAA151 Installation Manual download pdf (Page 102)

Installation Manual __________________________________________________________________

100 __________________________________________________________________ M010114en-B

4. Connect the signal cable to the connector Sol. Rad. at the

bottom of the equipment enclosure (see section Connecting

Cables on page 129).

CM11

See installation of CM6B on page 99.

QMN101

It is recommended to install the sensor at least 1.5 meters above the

surface in order to avoid shading effects and to promote spatial

averaging. Install the sensor as follows:

1. Attach the radiometer (6) to the extension arm (5). For the

numbers, see Figure 93 below.

2. Attach the sensor's extension arm (5) with the adapter (3).

3. Lead the cable (2) through the sensor arm (1).

4. Use the bolts (4) to attach the mounting piece (3) to the sensor

arm (1).

5. After you have installed the sensor, connect the signal cable to

NET Rad. connector at the bottom of the equipment enclosure

(see section Connecting Cables on page 129).

0202-012

Figure 93 Installing QMN101 Net Radiometer

DSU12

1. Install the sunshine duration sensor (see Figure 94 on page 101).

2. Pull the sensor cable close to the equipment enclosure. Cut the

cable to a proper length. Thread the cable through the connector

parts in the indicated order 1-2-3-4 (see Figure 87 on page 96).

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 132 133

No comments

Vaisala WAA151 Installation Manual Page 102