Vaisala WAA151 Installation Manual download pdf (Page 97)

Chapter 4 ________________________________________________________________ Installation

VAISALA ________________________________________________________________________ 95

RG13H

1. Loosen the three screws securing the outer tube to the base and

lift off the outer tube.

2. Connect the output signal cable through the grommet and into

the terminal block provided on the underside of the base. Then

seal it using a silicone rubber compound.

3. Place the base onto the site, using a spirit level with the three

leveling screws. Secure the locknuts.

4. It is advisable to permanently secure the base using the two

holding lugs provided. These accept either 9.5 mm or 3/8"

rawlbolts.

5. Carefully remove the restriction to bucket movement, fitted for

transit purposes, and check that the bucket does pivot.

6. Replace the outer tube and secure it into position.

DRD11A

1. Install the DRD11A Rain Indication Sensor on DKPSUP (see

Figure 86 below).

0105-062

Figure 86 DRD11A Installed on Support Arm

2. Pull the sensor cable close to the equipment enclosure. Cut the

cable to a proper length. Thread the cable through the connector

parts in the indicated order 1-2-3-4 (see Figure 87 on page 96).

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 132 133

No comments

Vaisala WAA151 Installation Manual Page 97