Vaisala WAA151 Installation Manual Page 86

  • Download
  • Add to my manuals
  • Print
  • Page
    / 133
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 85
Installation Manual __________________________________________________________________
84 ___________________________________________________________________ M010114en-B
the grounding instructions in WHP25 User's Guide. Assure that
no shield mesh gets on the circuit board.
6. Do the output wiring to the X4 removable screw terminal block
(see Figure 72 below). Tighten the output cable gland(s).
7. Carefully reattach the enclosure cover with the four screws.
MAINS
INPUT
1.0 - 2.0 A
F1
2AT
FUSES
8AT
F2
MAINS VOLTAGE
(X2, X3)
100V 115V 200V 215V 230V 245V
1
23
456
7
8
X4
X1
ELN
WARNING! Improper jumper setting
may cause damage.
38VAC 24VDC
0.9A
5.2A
A
Cout
DCout
(RG13H)
(WA25)
Total wire resistance
less than 0.3 ohms
recommended for
NOTE!
WA25 systems.
X2
X3
Factory
setting
Secondary
Primary
Figure 72 WHP25 Wiring Instructions
WAS425A/WAS425AH
0105-059
Figure 73 Ultrasonic Wind Sensor with the Sensor Support
Arm
The ultrasonic wind sensor comes in a custom shipping container.
Carefully remove the sensor from the container. Save the container
Page view 85
1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 132 133

Comments to this Manuals

No comments