APPENDIX 5 ________________________________________________________________________
128 ____________________________________________________________________ U263EN-1.4
ERROR MESSAGES
The DMP248 transmitters go through a self-diagnostics procedure
when the power is switched on. When the procedure does not reveal
any errors or faults, the transmitter starts operating normally. If errors
or faults are found, the transmitter outputs an error message. The error
messages can be divided into two groups: error messages after the
reset and error messages during operation.
LED symbols:
LED dark
LED blinking
l LED lit
Errors after reset
Display Serial bus
E11 CPU EEPROM ackn. error
E12 CPU EEPROM csum error
E21 PRB EEPROM ackn. error
E22 PRB EEPROM csum error
ackn. error = EEPROM is faulty
csum error = check sum is erroneous
The LEDs display these error types as follows:
Comments to this Manuals