Chapter 6 ____________________________________________________________ Troubleshooting
VAISALA _______________________________________________________________________ 153
The command with the signal name parameter (in the following case
TA) produces the following response:
/ > LASTVAL TAMeasQMH101_1 TA
Status:1 Value:20.490570
where
Status:1 = The value is valid.
Value:20.490570 = The validated value for the temperature
measurement is 20.49xxxx
Software Operation
After MAWS has been without power (for example when you start it
for the first time), check the time and date. The timed operations will
not work if the correct time is not set!
NOTE
The time and date must be set if the backup battery has been
disconnected.
There may be some problems if you see either of these prompts:
/E>
/W>
/ E> means that there are errors and / W> means that there are
warnings.
It is normal to have one or two warnings after the serial connection to
MAWS has been reset, for example, you have turned your PC off and
so it is nothing to be worried about.
To see active warnings, type warnings. To clear active warnings, type
warnings clear. Warnings indicate that there are some problems in
the software.
Comments to this Manuals